Component - Plastics

File Number: E121855

FORMEX, DIV OF ILLINOIS TOOL WORKS INC

425 N Gary Ave

Formex N3-(b)(d)(e)(k)(L)(f2)

Polycarbonate (PC)

-- (b) May have additional suffix letter(s) indicating color.
-- (d) May have additional suffix letter(s) indicating color.
-- (e) Meets the requirements for IEC 60950-1, IEC 61558-1 Mandrel Test at 0.16 mm, 0.19 mm and 0.25 mm thickness at 7KvAC
-- (f2) Subjected to one or more of the following tests: Ultraviolet Light, Water Exposure or Immersion in accordance with UL 746C, where the acceptability for outdoor use is to be determined by UL.
-- (k) Complies with the IEC 60695-11-5, 12 mm Flame Test (60 Sec flame duration).
-- (L) Meets the requirements for Reinforced Insulation and Supplementary Insulation requirements in IEC60950-1 , IEC62368-1, IEC61558-1, IEC60065 and IEC61347-1 at thicknesses between 0.16 mm and 0.25 mm inclusive
-- NOTE HVTR, CTI and D495 are not dependent on thickness

Create your free Prospector account to view this complete UL Yellow Card. A free account includes access to thousands of detailed Yellow Cards. Create Your Free Account

Flammability	Nominal Value	Unit	Test Method
Flame Rating			UL 94, ISO 9773
0.0020 in, NC, BK
0.0063 in, NC, BK
0.0075 in, NC, BK
0.0098 in, NC, BK
Electrical	Nominal Value	Unit	Test Method
Hot-wire Ignition (HWI)			UL 746A
0.0020 in
0.0063 in
0.0075 in
0.0098 in
High Amp Arc Ignition (HAI)			UL 746A
0.0020 in
0.0063 in
0.0075 in
0.0098 in
Comparative Tracking Index (CTI)			UL 746A
Dielectric Strength		V/mil	ASTM D149
High Voltage Arc Tracking Rate (HVTR)			UL 746A
Inclined-Plane Tracking		kV	ASTM D2303
Volume Resistivity		ohms·cm	ASTM D257, IEC 60093
Thermal	Nominal Value	Unit	Test Method
RTI Elec			UL 746B
0.0020 in		°F
0.0063 in		°F
0.0075 in		°F
0.0098 in		°F
RTI Str			UL 746B
0.0020 in		°F
0.0063 in		°F
0.0075 in		°F
0.0098 in		°F
Physical	Nominal Value	Unit	Test Method
Outdoor Suitability			UL 746C

UL LLC ©2023. All rights reserved.
The information presented here was acquired by UL from the producer of the product or material or original information provider. However, UL assumes no responsibility or liability for the accuracy of the information contained on this website and strongly encourages that upon final product or material selection information is validated with the manufacturer. This website provides links to other websites owned by third parties. The content of such third party sites is not within our control, and we cannot and will not take responsibility for the information or content.